Brocade Fabric OS Encryption Administrator’s Guide Support Manuel d'utilisateur télécharger pdf (Page 121)

Fabric OS Encryption Administrator’s Guide (DPM) 101

53-1002922-01

Rekeying all disk LUNs manually

Setting disk LUN Re-key All

To rekey all disk LUNs on an encryption node, complete these steps:

1. Select Configure > Encryption from the menu task bar to display the Encryption Center

dialog box. (Refer to Figure 6 on page 14.)

2. Select the switch on which to perform a manual re-key from the Encryption Center Devices

table, then select Switch > Re-Key All from the menu task bar. (Refer to Figure 75.)

FIGURE 75 Selecting the Re-Key All operation

If REPL support is enabled on the encryption group, a confirmation dialog box displays, asking

whether to rekey mirror LUNs.

3. Click Yes to includes mirror LUNs, or click No to exclude mirror LUNs.

A warning displays, requesting confirmation to proceed with the rekey operation.

4. Click Yes.

Rekeying operations begin on up to 10 LUNs. If more than 10 LUNs are configured on the

switch, the remaining rekey operations are held in the pending state.

5. Open the Encryption Target Disk LUNs dialog box to see LUNs being rekeyed and LUNs

pending.

a. Select Configure > Encryption from the menu task bar to display the Encryption Center

dialog box. (Refer to Figure 6 on page 14.)

b. Select the encryption switch from the Encryption Center Devices table, then select Targets

from the menu task bar.

The Encryption Targets dialog box displays. (Refer to Figure 47 on page 64.)

6. Select a disk LUN device from the table, then click LUNs.

The Encryption Targets Disk LUNs dialog box displays. (Refer to Figure 76.) The dialog box lists

the status of the rekey operation.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 331 332

Pas de commentaire

Brocade Fabric OS Encryption Administrator’s Guide Support Manuel d'utilisateur Page 121