Brocade Mobility RFS Controller CLI Reference Guide (Suppo Manuel d'utilisateur télécharger pdf (Page 20)

Brocade Mobility RFS Controller CLI Reference Guide 1

53-1003098-01

Chapter

INTRODUCTION

This chapter describes the commands available within a device’s Command Line Interface (CLI)

structure. CLI is available for wireless controllers, access points (APs), and service platforms.

Access the CLI by using:

• A terminal emulation program running on a computer connected to the serial port on the

device (access point, wireless controller, and service platform).

• A Telnet session through Secure Shell (SSH) over a network.

Configuration for connecting to a Controller using a terminal emulator

If connecting through the serial port, use the following settings to configure your terminal emulator:

When a CLI session is established, complete the following (user input is in bold):

administrator’s login password: <password>

User Credentials

Use the following credentials when logging into a device for the first time:

When logging into the CLI for the first time, you are prompted to change the password.

Examples in this reference guide

Examples used in this reference guide are generic to each supported wireless controller, service

platform, and AP model. Commands that are not common, are identified using the notation

“Supported in the following platforms.” For an example, see below:

Supported in the following platforms:

• Wireless Controller – Brocade Mobility RFS6000

The above example indicates the command is only available for a Brocade Mobility RFS6000 model

wireless controller.

Bits Per Second 19200

Data Bits 8

Parity None

Stop Bit 1

Flow Control None

User Name admin

Password admin123

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 134 135

Pas de commentaire

Brocade Mobility RFS Controller CLI Reference Guide (Suppo Manuel d'utilisateur Page 20