Brocade Encryption Switch Hardware Reference Manual (Suppo Manuel d'utilisateur télécharger pdf (Page 34)

20 Brocade Encryption Switch Hardware Reference Manual

53-1001117-02

FIGURE 8 Installing an SFP into an upper port

4. Connect the cables to the transceivers.

The cables used in trunking groups must meet specific requirements. For a list of these

requirements, see the Fabric OS Administrator’s Guide.

NOTE

The cable connectors are keyed to ensure correct orientation. If a cable does not install easily,

ensure that it is correctly oriented.

a. Orient a cable connector so that the key (the ridge on one side of the connector) aligns

with the slot in the transceiver. Then, insert the cable into the transceiver until the latching

mechanism clicks. For instructions specific to cable type, see the cable manufacturer’s

documentation.

b. Repeat Step a for the remaining cables.

5. Check the LEDs to verify that all components are functional. For information about LED

patterns, see “Interpreting LEDs”.

6. Verify the correct operation of the switch by entering the switchShow command from the

workstation.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 59 60

Pas de commentaire

Brocade Encryption Switch Hardware Reference Manual (Suppo Manuel d'utilisateur Page 34