Brocade Network OS NETCONF Operations Guide v4.1.1 Manuel d'utilisateur télécharger pdf (Page 493)

100

101

Network OS NETCONF Operations Guide 461

53-1003231-02

Restrictions for Layer 3 features in VCS mode

<cee>default</cee>

</interface>

</config>

</edit-config>

</rpc>

<rpc-reply message-id="2342" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">

<ok/>

</rpc-reply>

Restrictions for Layer 3 features in VCS mode

For an overview of Layer 3 restrictions in VCS mode, refer to the Network OS Administrator’s Guide.

Port-based Policier

For an overview of port-based Policer and associated policing parameters, binding rules,

limitations, and other considerations, refer to the Network OS Administrator’s Guide.

Configuring Policer functions

To configure port-based Policer functions, perform the following steps.

1. Configure a class map to classify traffic according to traffic properties that you will configure

with the policing parameters while adding the class map to a policy map. Refer to “Configuring

a class map” on page 461.

2. Configure a police priority map to add color-based priority mapping. Refer to “Configuring a

police priority map” on page 462.

3. Configure a policy map to associate QoS and policing parameters to traffic belonging to

specific classification maps. Each policy map can contain multiple classification maps. This is

an optional step if you want to change the default CoS values for color-based priority mapping.

Refer to “Configuring the policy map” on page 464.

4. Bind the policy map to a specific interface. Refer to “Binding the policy map to an interface” on

page 466.

Configuring a class map

The classification map or “class map” classifies traffic based on match criteria that you can

configure. If traffic matches this criteria, it belongs to the class. Currently, the only match criteria is

“match any.” With a “match any” criteria, traffic with any MAC address, IP address, VLAN ID, IP

precedence, Access Control List (ACL) security, or other identification belongs to the class.

When you add the class map to a Policy Map, the traffic defined by the class is subject to actions of

the QoS and policer parameters configured in the Policy Map. For more information on policer

parameters, refer to the Network OS Administrator’s Guide.

To configure a class map, perform the following steps.

1 2 ... 488 489 490 491 492 493 494 495 496 497 498 ... 621 622

Commentaires sur ces manuels

Pas de commentaire

Brocade Network OS NETCONF Operations Guide v4.1.1 Manuel d'utilisateur Page 493

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour ordinateurs Brocade Network OS NETCONF Operations Guide v4.1.1