Brocade Multi-Service IronWare Routing Configuration Guide Manuel d'utilisateur télécharger pdf (Page 145)

100

101

Multi-Service IronWare Routing Configuration Guide 117

53-1003033-02

Displaying BGP4 information

You can display the following configuration information and statistics for BGP4 protocol:

• Summary BGP4 configuration information for the device

• Active BGP4 configuration information (the BGP4 information in the running configuration)

• Neighbor information

• Peer-group information

• Information about the paths from which BGP4 selects routes

• Summary BGP4 route information

• The device’s BGP4 route table

• Route flap dampening statistics

• Active route maps (the route map configuration information in the running configuration)

• BGP4 Restart Neighbor Information

• AS4 support and asdot notation

Displaying summary BGP4 information

You can display the local AS number, the maximum number of routes and neighbors supported,

and some BGP4 statistics. You can also display BGP4 memory usage for:

• BGP4 routes installed

• Routes advertising to all neighbors (aggregated into peer groups)

• Attribute entries installed

The show ip /jointfilesconvert/1441120/bgp summary command output has the following limitations:

• If a BGP4 peer is not configured for an address-family, the peer information is not displayed.

• If a BGP4 peer is configured for an address-family but not negotiated for an address-family

after the BGP4 peer is in the established state, the show ip /jointfilesconvert/1441120/bgp summary command output

shows (NoNeg) at the end of the line for this peer.

• If a BGP4 peer is configured and negotiated for that address-family, its display is the same as

in previous releases.

To view summary BGP4 information for the device, enter the following command at any CLI prompt

Syntax: show ip /jointfilesconvert/1441120/bgp summary

Brocade# show ip /jointfilesconvert/1441120/bgp summary

BGP4 Summary

Router ID: 10.10.1.14 Local AS Number: 100

Confederation Identifier: not configured

Confederation Peers:

Maximum Number of IP ECMP Paths Supported for Load Sharing: 1

Number of Neighbors Configured: 67, UP: 67

Number of Routes Installed: 258088, Uses 22195568 bytes

Number of Routes Advertising to All Neighbors: 17,035844 (3,099146 entries),

Uses 192,147052 bytes

Number of Attribute Entries Installed: 612223, Uses 55100070 bytes

Neighbor Address AS# State Time Rt:Accepted Filtered Sent ToSend

10.0.100.2 100 ESTABp 0h28m24s 0 0 258087 0

10.0.101.2 100 ESTAB 0h28m24s 0 0 258087 0

10.2.3.4 200 ADMDN 0h44m56s 0 0 0 2

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 845 846

Commentaires sur ces manuels

Pas de commentaire

Brocade Multi-Service IronWare Routing Configuration Guide Manuel d'utilisateur Page 145

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour ordinateurs Brocade Multi-Service IronWare Routing Configuration Guide