Brocade Multi-Service IronWare Routing Configuration Guide Manuel d'utilisateur télécharger pdf (Page 327)

100

101

Multi-Service IronWare Routing Configuration Guide 299

53-1003033-02

Displaying IPv4 IS-IS information

Circuit Type The type of IS-IS circuit running on the interface. The circuit type can be

one of the following:

• BCAST (broadcast).

• PTP (Point-to-Point)

Passive State The passive state determines whether the interface is allowed to form an

IS-IS adjacency with the IS at the other end of the circuit. The state can

be one of the following:

• FALSE – The passive option is disabled. The interface can form an

adjacency with the IS at the other end of the link.

• TRUE – The passive option is enabled. The interface cannot form

an adjacency, but can still advertise itself into the area.

Circuit Number The ID that the instance of IS-IS running on the interface applied to the

circuit between this interface and the interface at the other end of the

link.

MTU The maximum length supported for IS-IS PDUs sent on this interface.

Level-1 Auth-mode One of the following authentication modes set for Level-1 on the router:

• None

• md5

• cleartext

Level-2 Auth-mode One of the following authentication modes set for Level-2 on the router:

• None

• md5

• cleartext

This parameter is not displayed for interfaces that are configured with a

Point-to-Point circuit type. This is because separate Level-2 Hello

messages are not sent on Point-to-Point interfaces. Consequently, "Hello

Interval", "Hello Multiplier", and "Authentication" parameters should

always be configured in the Level-1 mode for Point-to-Point interfaces.

Level-1 Metric The default-metric value that the Brocade device inserts in IS-IS Level-1

PDUs for this interface.

Level-1 Priority The priority of this IS to be elected as the Designated IS for Level-1 in this

broadcast network.

Level-1 Hello Interval The number of seconds the software waits between sending Level-1

hello PDUs to the IS at the other end of the circuit.

Level-1 Hello Multiplier The number by which the software multiplies the hello interval to

calculate the hold time set in Level-1 Hello PDUs sent on the circuit.

Level-1 Designated IS The NET of the Level-1 Designated IS.

Level-1 DIS Changes The number of times the NET of the Level-1 Designated IS has changed.

Level-2 Metric The default-metric value that the Brocade device inserts in IS-IS Level-2

PDUs for this interface.

Level-2 Priority The priority of this IS to be elected as the Designated IS for Level-2 in this

broadcast network.

Level-2 Hello Interval The number of seconds the software waits between sending Level-2

Hello messages to the IS at the other end of the circuit.

TABLE 42 IS-IS interface information (Continued)

This field... Displays...

1 2 ... 322 323 324 325 326 327 328 329 330 331 332 ... 845 846

Commentaires sur ces manuels

Pas de commentaire

Brocade Multi-Service IronWare Routing Configuration Guide Manuel d'utilisateur Page 327

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour ordinateurs Brocade Multi-Service IronWare Routing Configuration Guide