Brocade Multi-Service IronWare Routing Configuration Guide Manuel d'utilisateur télécharger pdf (Page 329)

100

101

Multi-Service IronWare Routing Configuration Guide 301

53-1003033-02

Displaying IPv4 IS-IS information

Displaying route information

To display the routes in the Brocade device’s IS-IS route table, use either of the following methods.

To display information about the routes in the Brocade device’s IS-IS route table, enter the following

command at any level of the CLI.

Syntax: show isis routes [ip-address subnet-mask | ip-address/prefix]

You may enter ip-address subnet-mask or ip-address/prefix if you want information for a specific

route.

Example

This display shows the following information.

IPv6 Enabled If set to TRUE, the IPv6 protocol is enabled for this circuit.

IPv6 Address and Subnet Mask The IPv6 address and subnet mask for this interface.

Ipv6 Link-Local Addresses The IPv6 link local address for this interface.

MPLS TE Enabled: If set to TRUE, MPLS Traffic Engineering protocol is enabled for this

circuit.

BFD Enabled: If set to TRUE, BiDirectional Forwarding Detection is enabled for this

circuit.

TABLE 43 IS-IS route information

This field... Displays...

Total number of IS-IS routes The total number of routes in the Brocade device’s IS-IS route table. The

total includes Level-1 and Level-2 routes.

Destination The IP destination of the route.

Mask The subnet mask for the destination address.

Cost The IS-IS default metric for the route, which is the cost of using this route

to reach the next-hop router to this destination.

Type The route type, which can be one of the following:

• L1 – Level-1 route

• L2 – Level-2 route

TABLE 42 IS-IS interface information (Continued)

This field... Displays...

Brocade# show isis routes

Total number of IS-IS routes: 173

Destination Mask Cost Type Tag Flags

10.0.0.0 255.255.255.0 21 L2 00000000 00000242